[Koha] Patron Card Creator

Vitor Fernandes vitorfernandes87 at gmail.com
Wed Feb 23 05:06:46 NZDT 2011


I can't believe that I didn't notice that.... That solved my problem.
Thank's bob...

The problem with the cuted cards was solved by limiting the column and
row number to 2 and 4 with 1cm margin...

Regards
Vitor Fernandes

2011/2/22 Bob Ewart <bob-ewart at bobsown.com>:
> On 02/22/2011 09:33 AM, Vitor Fernandes wrote:
>> Hi there.
>>
>> I'm having a little problem with the module patron card creator.
>> I've created a layout and a template in order to implement the patron
>> card needed, but i'm having a problem with the printing.
>>
>> The cards most have the following dimensions: 7.7cm of width and 4.8cm
>> of height, which i've set up correctly in the template
>> Next the cards most be printed in A4 paper, so i've set up in the
>> template, 21cm in page width and 29.7cm of height.
>>
>> The problem is that after export and print one batch with one card the
>> card appears too small. If I reduce the page dimensions in the card
>> appers in the right size.
>> If I export and print a batch with some cards, the cards appears too
>> smal and in the page change they are cut... I've tried to change the
>> page dimensions with no success.
>>
>> So If someone can help me to configure this correctly, i'll be
>> thankfully... I only want to print 4.8x7.7cm cards in A4 paper without
>> no cuted cards on the page changes.
>>
>> Regards.
>> Vitor Fernandes.
>> _______________________________________________
>
> When printing a PDF, you must select Scaling: none in the print window.
> Otherwise it will shrink the page.
>
> --
> Bob
>
> _______________________________________________
> Koha mailing list  http://koha-community.org
> Koha at lists.katipo.co.nz
> http://lists.katipo.co.nz/mailman/listinfo/koha
>


More information about the Koha mailing list