[Koha] Question about accessing singleton koha instance

[Christos Hayward]

I didn't see the webinstaller; I was going off of
https://wiki.koha-community.org/wiki/Debian

For create_superlibrarian.pl, what are appropriate arguments for the
branchcode, categorycode, and cardnumber (for as many as are required)?


Thanks,

On Wed, Nov 27, 2019 at 12:07 PM Tomas Cohen Arazi <tomascohen at gmail.com>
wrote:

> If this is a 'packages' install, you need to:
>
> $ sudo koha-shell catalog
> $ /usr/share/koha/bin/devel/create_superlibrarian.pl ...
>
> You need to pass create_superlibrarian.pl valid parameters. Is the
> instance initiated with data? Did you see the webinstaller?
>
>
> El mié., 27 nov. 2019 a las 14:56, Christos Hayward (<
> christos.hayward at gmail.com>) escribió:
>
>> I have:
>>
>>    - Created a single Koha instance called "catalog".
>>    - Set catalog-intra to the same machine in /etc/hosts.
>>    - Set the generated VirtualHost in
>>    /etc/apache2/sites-enabled/catalog.conf to listen on 8080 as well as
>>    additionally telling Apache to listen on 8080.
>>
>> On accessing the administrative interface on 8080, I am prompted for a
>> username and password, and been unable to log in as kohauser, with either
>> the randomly password connected to koha.conf, or another manually
>> specified
>> password it is globally replaced with, or running from the command-line
>> koha-password catalog.
>>
>> How can I get to the point of logging in as an administrator to the only
>> instance through the 8080 administrative web interface?
>>
>> --
>> Christos Hayward
>> _______________________________________________
>> Koha mailing list  http://koha-community.org
>> Koha at lists.katipo.co.nz
>> https://lists.katipo.co.nz/mailman/listinfo/koha
>>
>
>
> --
> Tomás Cohen Arazi
> Theke Solutions (http://theke.io)
> ✆ +54 9351 3513384
> GPG: B2F3C15F
>


-- 
Christos Hayward