Thanks to all who have offered advice recently. I discovered that part of the problem in my first install was that I skipped a step when installing Koha, the dselect debian packages. I finally did a clean install of the server software and started again. The only problem I had and I finally resolved it was with ImageMagick. You need to install PerlMagick as well to make everything work. Now my problem is probably very simple, but I did not have any problems like this with Ubuntu 7.10. I am using Debian Etch and I am having trouble getting port 80 or 8080 to work properly. I can go to the console (using Gnome) and use the browser to go to http://127.0.0.1 <http://127.0.0.1/> or http://127.0.0.1:8080 <http://127.0.0.1:8080/> and everything is fine. When I use the IP address I get the default IP Apache web page ("It Works!). Doesn't matter if I specify a port or not. When I edit the conf file for koha and put in the IP address, it works, but then I lose the ability to use phpmyadmin. John +----------------------------------------------------------------------- -----+ John Chadwick, Ed.D. Information Technology Manager New Mexico State Library 1209 Camino Carlos Rey Santa Fe, NM 87507 Phone: 505-476-9740 Cell: 505-629-8116 Fax: 505-476-9761 john.chadwick@state.nm.us http://www.nmstatelibrary.org Confidentiality Notice: This e-mail, including all attachments is for the sole use of the intended recipient(s) and may contain confidential and privileged information. Any unauthorized review, use, disclosure or distribution is prohibited unless specifically provided under the New Mexico Inspection of Public Records Act. If you are not the intended recipient, please contact the sender and destroy all copies of this message. -- This email has been scanned by the Sybari - Antigen Email System.