Printing Spine Labels in Koha 3.2
Greetings! I am new to Koha (this is my second week using it) and am thus new to printing spine labels using Koha. I have run into some label printing problems, and would greatly appreciate any words of advice from those of you who have sucessfully printed spine labels. Some background: I use DEMCO WS14217670 labels (8 1/2 x 11 sheets of 1" x 1.5# labels). The first three columns are perfectly aligned and centered. The last four columns of label data are not; they need to be shifted to the right, but I am at a loss as to how to do so. Any suggestions, ideas or advice would be most welcome! Thank you in advance, Sharon Reidt Technical Services Specialist Marlboro College Marlboro, Vermont, USA
Hi Sharon, On Wed, Jun 16, 2010 at 9:28 AM, Sharon Reidt <sreidt@marlboro.edu> wrote:
Greetings!
I am new to Koha (this is my second week using it) and am thus new to printing spine labels using Koha. I have run into some label printing problems, and would greatly appreciate any words of advice from those of you who have sucessfully printed spine labels.
Some background: I use DEMCO WS14217670 labels (8 1/2 x 11 sheets of 1" x 1.5# labels). The first three columns are perfectly aligned and centered. The last four columns of label data are not; they need to be shifted to the right, but I am at a loss as to how to do so.
Any suggestions, ideas or advice would be most welcome!
Take a look at this and see if it helps: http://koha-community.org/documentation/3-2-manual/?ch=x4192#AEN4263 Kind Regards, Chris
participants (2)
-
Chris Nighswonger -
Sharon Reidt