Another tip: if you're having a problem getting the correct <user> string, give this program a try: http://www.ldapadministrator.com/download.htm James Winter 215.517.2588 From: Barry Cannon [mailto:bc@interleaf.ie] Sent: Thursday, February 12, 2009 12:06 PM To: Winter, James Subject: RE: [Koha] FW: Koha 3.0 LDAP Question? Yes, I am using Active Directory. Do you have any tips? From: Winter, James [mailto:WinterJ@arcadia.edu] Sent: 12 February 2009 17:06 To: Barry Cannon Subject: RE: [Koha] FW: Koha 3.0 LDAP Question? Are you using Active Directory? James Winter 215.517.2588 From: koha-bounces@lists.katipo.co.nz [mailto:koha-bounces@lists.katipo.co.nz] On Behalf Of Barry Cannon Sent: Thursday, February 12, 2009 9:17 AM To: koha@lists.katipo.co.nz Subject: [Koha] FW: Koha 3.0 LDAP Question? I have been trying to configure LDAP and have a couple of questions: The Wiki says: There are two parts of the KOHA_CONF file (default location: /etc/koha.xml) relevant to LDAP authentication: the configuration stanza itself, and the "switch" line that enables or disables LDAP. The switch appears in the main <config> section, 0 for "off" and 1 for "on",.... Should I take this to mean the koha-conf.xml file? There is no koha.xml file on our installed server? If it is this file, do I simply add the LDAP server options in the config file. I have assumed that is what is needed but I can't figure out where to go from there? Is there an Admin tool to configure/test the LPAD authentication? Thanks Barry